Every Ghoul needs a mask! Now you can make your own just like Ken Kaneki’s and bring it to Tokyo Ghoul: The Movie!
Tickets are already on sale, so grab yours now before they run out. The movie will be in select theaters October 16-22 – buy tickets here! Like the mask? Thank our awesome partners in Japan for designing this cool paper craft.
Download the printable file here, and follow the instructions below!
Gather your materials:
- Your mask, printed on a piece of 11×17” cardstock paper, double-sided
- X-ACTO knife
- Pair of scissors
- 3 thin rubber bands
This image shows the front side (the side where you see the teeth)
Cut out your pieces (with the front side facing up)
With the front side (side with teeth) facing you, cut along the thin white borders of each of the 6 pieces with a pair of scissors or X-ACTO knife.
You should have a total of 6 pieces (5 large pieces, and 1 small zipper piece). Be careful not to lose the zipper piece! From the top, these are pieces [C], [A], zipper [F], [E], [D], and [B]. They should be labeled on the back.
With the front side face up, cut along the other white lines with an X-ACTO knife (many of these will be slots for pieces to fit into).
After the additional cuts, they should look like below (the back side is shown for all here).
Fold along the dashed lines
For every dashed line on the back, look at the label and fold either a mountain fold…
…or a valley fold.
After folding the 5 pieces with dashed lines, your pieces should look like this:
Assemble the mask by putting the matching parts together
3.1. On piece [A], slide the pieces labeled  together so that the number  does not show
3.2. Next, on piece [B], slide tab  from the back side into slot  (it says “” on the backside). Slide tab  from the back side into slot  as well
Afterwards, it should look like this:
3.3. Now to put all 6 pieces together
Grab pieces [C], [D], and [E]…
Put tab  of piece [C] with the flaps down into slot  of piece [D] from the front side. Open the flaps on the back side so it’s secure
Put tab  of piece [C] with the flaps down into slot  of piece [E] from the front side. Make sure the flaps are open on the back
After putting  and  in, you should have this (as seen from the back)
Next, put tab  of piece [C] into slot  of piece [A]. Make sure you open the flaps
Moving on, put tab  of piece [A] into slot  of piece [B] (it may be hidden by tab ) from the front side
Put tab  of piece [A] into slot  of piece [B] (it may be covered by tab ) from the front side
After putting  and  in, it should look like this on the back
Put the small zipper piece [F] with tab  into slot  of piece [B] from the back
Afterwards, it should look like this from the front:
Lastly, put on the rubber bands
Slide in a rubber band into the slits at the end of part [D] and [E]
Put a rubber band through the holes of pieces [A] and [B] on the right side
Pull the rubber band section from the back through the section in front and tighten
Repeat for the left side and you’re DONE!
Show us how yours looks using #TokyoGhoulMovie!
The post How to Put Together Your Own Tokyo Ghoul Paper Craft Mask appeared first on Funimation – Blog!.